How to open a laptop install#

For ease of access, disconnect the optical drive board.Remove the optical DVD driveвЂ™s screw that holds it in place & Unplug the power cord from the motherboard.Remove the optical DVD driveвЂ™s screw that holds it in place Unplug the power cord from the motherboard.Unplug the power cord from the motherboard. LoosingВ the screw will fix the USB LED status board.

How to open a laptop install#

You can install up to two memory modules on the HP 15 notebook motherboard.YouвЂ™ll have to move the bracket and the SATA cable to the new drive as well. If the hard drive or SSD is about to fail, replace it with a new one instead.I suggest upgrading the standard drive to a 2.5вЂі SATA solid-state drive for better performance. Normal hard drives are unsuitable for storage devices.Open the laptop and remove the hard drive assembly.The cable should be pulled out of the connector.Allow the locking tab to be carefully raised to release the cable.Okay Next, Unlock the connector and release the cable.Remove the hard drive cable (a yellow-colored one) from the motherboard (exhausted hard drive warning).Use a small Phillips screwdriver to remove the three screws that are holding the hard drive bracket to the case.Rotate the laptop 180 degrees and pull the bottom plate off.The best way to remove the palm rest from the bottom case is to use a plastic case opener.Find all of the screws that were not visible when you assembled the notebook. To solve the problem, simply remove the bottom screw from the case.The CD/DVD drive should be unsecured before disassembly.

In addition, batteries for this equipment are available

The procedure for disassembling every electronic device begins with removing the battery.